Results of an "emergency quality control study" as confirmation of a PCDD/PCDF-contamination of milk and butter samples

Elevated PCDD/F levels in four butter samples and one milk sample had to be confirmed under considerable time pressure. These samples should demonstrate a raising dioxin contamination in different regions of Germany caused by the use of Brazilian citrus pulp as feedstuff. Above all, the increase of 2,3,7,8-TCDD and 1,2,3,7,8-PeCDD had to be confirmed. Thus, an "emergency quality control study" was performed including five laboratories from the official food control in Germany. The results had to be reported about two to three weeks after the first announcement of the samples (including time for shipment). The five laboratories applied different extraction and clean-up methods, used different GC-columns and GC/MS-equipment and different standard solutions. The results are in a good agreement. Slightly different results for most individual congeners were of minor importance. A difference was observed only in the 2,3,7,8-TCDF content of one laboratory which was not relevant for the evaluation of the increase of the dioxin contamination in milk and dairy products. The laboratory's individual methods proved to give correct results even under a very tight schedule.     

The SeKT joint research project: definition of reference conditions, control sediments and toxicity thresholds for limnic sediment contact tests

- In current biotest approaches, intact organisms or in vitro systems are exposed to sediments using different exposure scenarios. The most important issue in sediment toxicity testing protocols is the question which test phase (solid or liquid) should be used. Whole-sediment exposure protocols represent the most realistic scenario to simulate in situ exposure conditions in the laboratory. However, until now there is no agreement in how to acquire and to evaluate the data of the various available sediment contact assays. The SeKT joint research project was initiated with the aim to compare recently developed sediment contact assays by addressing reference conditions, control sediments and toxicity thresholds for limnic sediment contact tests.     

Rapid tissue reduction and recovery in the sponge <Emphasis Type="Italic">Aplysinella</Emphasis> sp.

We observed a pronounced, yet reversible tissue reduction in the tropical sponge Aplysinella sp. under non-experimental conditions in its natural habitat, after transfer into seawater tanks, as well as after transplantation from deep to shallow water in the field. Tissue reduction resulted in the formation of small “reduction bodies” tightly attached to the sponge skeleton. Although volume loss and gain were substantial, both tissue reduction and regeneration were often remarkably rapid, occurring within few hours. Microscopic analysis of the reduction bodies revealed morphological similarities to previously described sponge primmorphs, with densely packed archaeocytes and spherulous cells enclosed by a thin layer of epithelial-like cells. Denaturing gradient gel electrophoresis (DGGE) revealed pronounced changes in the sponge-associated microbial community upon tissue reduction during laboratory and field experiments and following changes in ambient conditions after transplantation in the field. Generally, the microbial community associated with this sponge proved less stable, less abundant, and less diverse than those of other, previously investigated Verongid sponges. However, one single phylotype was consistently present in DGGE profiles of Aplysinella sp. This phylotype clustered with γ-proteobacterial sequences found previously in other sponge species of different taxonomic affiliations and geographic provenances, as well as in sponge larvae. No apparent changes in the total secondary metabolite content (per dry weight) occurred in Aplysinella sp. upon tissue reduction; however, comparative analysis of intact and reduced tissue suggested changes in the concentrations of two minor compounds. Besides being ecologically interesting, the tissue reduction phenomenon in Aplysinella sp. provides an experimentally manipulable system for studies on sponge/microbe symbioses. Moreover, it may prove useful as a model system to investigate molecular mechanisms of basic Metazoan traits in vivo, complementing the in vitro sponge primmorph system currently used in this context.     

Calcite-seeded crystallization of calcium phosphate for phosphorus recovery

For phosphorus recovery from wastewater, the present paper aims at understanding the crystallization of calcium phosphate by using calcites (Juraperle and Coccolith) as seeds from hard water. Synthetic hard water with 60 mgCl(-1) carbonate and 10 mgPl(-1) phosphate was prepared and used in the batch experiments of calcite-seeded crystallization. The solution composition was measured throughout the batch crystallization process, and the corresponding saturation indices with respect to the minerals were calculated with PHREEQC Program. The surface of the calcite seeds was observed and measured with environmental scanning electron microscopy (ESEM), Fourier transform infrared (FTIR) and BET method. The studies show that both calcites are effective seeds for the crystallization of calcium phosphate from hard water; the used calcites are more efficient than the original ones because newly formed crystals with calcium phosphate have covered their surfaces. The studies show that the calcite seeds can be used for phosphorus recovery from hard waters.     

Fluidized-bed-combustion ash for the solidification and stabilization of a metal-hydroxide sludge

Fluidized-bed-combustion (FBC) ash is a by-product from a developing technology for coal-fired power plants that will economically reduce air emissions to meet requirements of the Clean Air Act. FBC ash has physical and chemical properties similar to Portland cement, but only has moderate success as a pozzolan in concrete applications due to low compressive strengths. However, FBC ash has proven effective for use as a binder for the solidification and stabilization (S/S) of metal-bearing sludges. Physical and chemical characterization procedures were used to analyze FBC ash and a metal-bearing sludge obtained from a hazardous waste treatment facility to develop 12 different S/S mix designs. The mix designs consist of four binder designs to evaluate sludge-to-binder ratios of approximately 0, 0.5, and 1. Portland cement is used as a control binder to compare unconfined compressive strengths and Toxicity Characteristic Leaching Procedure (TCLP) analyses from different ratios of the FBC ash streams: fly ash, char, and spent bed material (SBM). Compressive strengths ranging from 84 lbs per square inch (psi) to 298 psi were obtained from various mix designs containing different sludge-to-ash ratios cured for 28 days. All the mix designs passed the TCLP. Recoveries from leaching for each metal were less than 5% for most mix designs. Results of unconfined compressive strengths, TCLP, and percent recovery calculations indicate that the mix design containing approximately a 1:1 ratio of fly ash to char-and-sludge is the best mix design for the S/S of the metal-bearing sludge.     

Validation of a test method for the measurement of methanol emissions from stationary sources

Title III of the 1990 Clean Air Act Amendments designated methanol as a pollutant to be regulated. The U.S. Environmental Protection Agency (EPA), through a contract with Research Triangle Institute, has developed a method for measuring methanol emissions from stationary sources. The methanol sampling train (MST) consists of a glass-lined heated probe, two condensate knockout traps, and three sorbent cartridges packed with Anasorb 747. Samples are desorbed with a 1:1 mixture of carbon disulfide (CS2) and N,N-dimethylformamide (DMF). Condensate water and CS2/ DMF samples are analyzed by gas chromatography with flame ionization detection. The MST has a practical quantitation limit of approximately 3 ppm for a 20-L sample. Samples were shown to be stable for at least two weeks after collection. Field tests of the MST and the National Council of the Paper Industry for Air and Stream Improvement (NCASI) methanol sampling method were conducted at two pulp and paper mills. Sampling and analysis procedures followed EPA Method 301 requirements. The sampling location for the first field test was the inlet vent to a softwood bleach plant scrubber, where the methanol concentration was approximately 30 ppm. The mean recovery of spike was 108.3% for the MST method and 81.6% for the NCASI method. Although neither method showed significant bias at the 95% confidence level, the between-methods bias was significantly different. A second field test was conducted at a vent from a black liquor oxidation tank where the methanol concentration was approximately 350 ppm. Mean spike recoveries were 96.6 and 94.2% for the MST and NCASI methods, respectively. The biases of the two methods and the between-methods bias were not significantly different for the second field test.     

Cellular localisation of secondary metabolites isolated from the Caribbean sponge <Emphasis Type="Italic">Plakortis simplex</Emphasis>

The Caribbean sponge, Plakortis simplex, is known to contain a large array of secondary metabolites, including the antimalarial polyketide plakortin, several unusual glycolipids, and some hopanoids, which closely resemble typical bacterial metabolites. The hypothesis that they could be products of bacterial metabolism was tested by localizing specific metabolites in cells using physical separation of sponge cells, bacterial symbionts and supernatant by differential centrifugation. The obtained fractions were analysed separately for the typical P. simplex metabolites by NMR and mass spectrometry, and most of them were shown to be present in the bacterial cells but not in the sponge cells. In addition, PCR screening showed that the biosynthetic pathway for glycosphingolipids was present in the bacterial cells. Isolation of a Sphingomonas strain PS193 from P. simplex and subsequent glycosphingolipid analysis resulted in the detection of a known glycosphingolipid, GSL-1, that did, however, not match the glycosphingolipid profile of P. simplex. Therefore, it is unlikely that Sphingomonas strain PS193 is an abundant member of the microbial community associated with P. simplex. Other glycosphingolipid producing bacteria in P. simplex remain to be identified. In conclusion, this study provides experimental evidence that the glycolipids and hopanoids and possibly also the polyketide plakortin are produced by microbial symbionts rather than the sponge from which the metabolites were originally isolated.     

Controls on coarse wood decay in temperate tree species: birth of the LOGLIFE experiment

Dead wood provides a huge terrestrial carbon stock and a habitat to wide-ranging organisms during its decay. Our brief review highlights that, in order to understand environmental change impacts on these functions, we need to quantify the contributions of different interacting biotic and abiotic drivers to wood decomposition. LOGLIFE is a new long-term 'common-garden' experiment to disentangle the effects of species' wood traits and site-related environmental drivers on wood decomposition dynamics and its associated diversity of microbial and invertebrate communities. This experiment is firmly rooted in pioneering experiments under the directorship of Terry Callaghan at Abisko Research Station, Sweden. LOGLIFE features two contrasting forest sites in the Netherlands, each hosting a similar set of coarse logs and branches of 10 tree species. LOGLIFE welcomes other researchers to test further questions concerning coarse wood decay that will also help to optimise forest management in view of carbon sequestration and biodiversity conservation.